Pioneer HD VIDEO SYSTEM HD-V9000 - Manuel (Page 30)

03
30
En
Chapter 3
Connections
Be sure to turn off the power (set it to standby) then
unplug the power cord from the power outlet whenever
making or changing connections.
Also refer to the operating instructions of the device
being connected.
Connecting the HDMI
OUT terminal
Using a single cable, video and audio signals can be
transmitted to HDMI-compatible equipment as digital
signals with no loss of quality.
Note
• This unit is designed for connection with HDMI-
compatible devices. Do not connect DVI devices. This
unit may not operate properly if a DVI device is
connected.
• 1080p video signals may not be output, depending on
the HDMI cable being used.
About HDMI
This unit incorporates High-Definition Multimedia
Interface (HDMI
®
) technology.
• HDMI, the HDMI Logo and High-Definition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing, LLC in the United
States and other countries.
Note
• This unit does not support HDCP. HDCP is a standard
for protecting audio and video contents with HDMI or
DVI connections. Copyright-protected contents
cannot be played on this unit.
• This unit does not support Deep Color, xvYCC or CEC.
• For the video output resolutions, see Video output
formats on page 19.
 Audio signals that can be
transferred with the HDMI OUT
terminal
• Linear PCM (The following linear PCM signals can be
output):
– Sampling frequency: 48 kHz
– No. channels: 2
Attaching the HDMI
retaining cover
This unit comes with an HDMI retaining cover for
preventing the HDMI cable from coming loose. Be sure to
attach the cover.
Note
• Depending on type of HDMI cable connected, it may
not be possible to fasten the cable with the HDMI
retaining cover. In this case, fasten in place using the
four fixing holes used when using a binder in step 1
below.
• The connector sizes of HDMI cables which can be
fastened with the HDMI retaining cover are shown
below. However, depending on the shape of the
connector, the position of the cable, etc., it may not be
possible to fasten the cable.
Connector sizes of HDMI cables which can be fastened
with the HDMI retaining cover (reference values)
1 Attach the HDMI cable to this unit’s HDMI OUT
terminal.
Cable
Ø12 mm or less
18 mm to 21 mm
22 mm to 26 mm
10 mm to 12 mm
O
O
NTSC
C R / P
R
C B / P B
Y
T V SYST EM
PAL
VIDEO OUT
COMPONENT
VIDEO OUT
HDMI
OUT
DIGIT
AL AU DIO OUT
AU DIO OUT
R S -2
3 2 C
L
R
1
2
3
HDMI cable
Fixing holes for
binding (4 holes)
HDMI holder
HDMI screw hole
HDMI retaining cover
Screw