Pioneer VSX-415 - Manuel (Page 8)

5 minute guide 02
8
En
3 Connect your speakers.
A complete setup of speakers is shown here (six speakers for the VSX-415, and eight for the VSX-
515), but home setups may vary. Simply connect the speakers you have as shown below.
1
The
receiver will work with just two stereo speakers (the front speakers in the diagram) but using at
least three speakers is recommended, and a complete setup is best.
Make sure you connect the speaker on the right to the right terminal and the speaker on the left
to the left terminal. Also make sure the positive and negative (
+ / – ) terminals on the receiver match
those on the speakers. You can use speakers with a nominal impedance between 6–16 Ω (please
see Switching the speaker impedance on page 51 if you plan to use speakers with an impedance of
less than 8 Ω ).
Note
1 • If you’re not using a subwoofer, change the front speaker setting (see Speaker setting on page 38) to large.
• VSX-515 only – If you are using only one surround back speaker, connect the positive wire to the right channel ( + ) terminal,
and the negative wire to the left channel ( – ) terminal as shown.
AM LOOP
FM UNBAL 75 Ω
IN
IN
IN
MONITOR OUT
SUB WOOFER
SURROUND
SURROUND
CEN- TER
OUT
VIDEO
SUB
WOOFER
R AUDIO L
IN
IN
IN
IN
OUT
DIGITAL IN
OUT
IN
COAX
COAX
OPT
CD L R
L
R
DVR/ VCR
TV /
SAT (TV / SAT)
(DVD /LD)
(CD)
DVD /LD
PLAY
CD-R / TAPE / MD
FRONT
PREOUT
ASSIGNABLE
REC
1
1
2
ANTENNA
DVD 5.1CH INPUT
AC OUTLET
PREOUT
FRONT
SPEAKER
SURROUND
SPEAKERS
CENTER
SPEAKER
R L R L
D V D 5.1CH INPUT
INPUT
VSX-415
Front speakers
L R C LS RS
Powered subwoofer
SW
Surround speakers Center speaker
VSX_415-515.fm 8 ページ ２００４年１２月８日 水曜日 午後３時１２分