PYLE Audio HD-V9000 - Manuel (Page 49)

49
En
06
Englis
h
Network Settings
The network settings are made here. If settings are changed, be sure to either close the Setup screen or return to the
top Setup screen, then turn off the power. The settings are reflected when the power is turned back on (aside from the
Wake Up On LAN setting). For details on this unit’s network function, see page 70.
1. For instructions on inputting numbers, see page 38.
2. For instructions on inputting characters, see page 39.
3. The unit’s clock is set automatically at the following times:
– When the unit’s power is turned on
– At intervals of 1 hour after the unit’s power is turned on
– When the NTP-related settings are changed
Caution
• Prior permission from the distributor is required in order to access NTP servers on the Internet.
Play Menu
For details, see page 39.
Setting item Settings Description
Network Connection
Disable Select this when not using the LAN function.
Enable Select this when using the LAN function.
Type
Auto IP The IP address is set automatically.
DHCP The network settings are acquired from the DHCP server.
Manual Set the IP address manually.
IP Address Input this unit’s IP address. 1
Subnet Mask Input the subnet mask. 1
Default Gateway Input the default gateway. 1
Primary DNS Input the primary DNS server’s IP address. 1
Secondary DNS Input the secondary DNS server’s IP address. 1
Wake Up On LAN
Off The Wake Up On LAN function is disabled (page 70).
On
The Wake Up On LAN function is enabled (even if Network Connection is set to
Disable).
MAC Address Displays the MAC address.
FTP Username Input the FTP username. 2 (Default value: HDVIDEO)
FTP Password Register the FTP password. 1 (Default value: PASS)
FTP Port Input the FTP port. 1 (Default value: 00021)
Remote Port Sets the remote port. 1 (Default value: 10001)
Proxy Address To use the proxy server when connecting to the Internet to use the RSS function, set the address. 2
Proxy Port Set the proxy server’s port number. 1 (Default value: 01234)
NTP
Disable This unit’s clock is set to the time set at Clock Setting (page 47).
Enable
This unit’s clock is set automatically by acquiring the time information from the
NTP server. 3 Clock Setting cannot be set (page 47).
NTP Server Address Set the NTP server’s IP address or URL. 2
Time Zone
GMT ± **:**
(GMT ± 00:00)
Set the offset time with respect to the time acquired from the NTP server (GMT).