Pioneer D514 - Manuel (Page 44)

Additional information 09
44
En
Specifications (VSX-D414)
Amplifier Section
Continuous Power Output (Stereo RMS)
Front ........................................................... 120 W
(1 kHz, THD 0.2 %, 8
Ω)
Continuous Power Output (Surround RMS)
Front ...................................... 120 W per channel
(1kHz, THD 10 %, 8 Ω)
Center .................. 120 W (1kHz, THD 10 %, 8 Ω)
Surround ............................... 120 W per channel
(1kHz, THD 10 %, 8 Ω)
Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ........................... 200 mV/47 k
Ω
Frequency Response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT ........................... 5 Hz to 100,000 Hz dB
Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/MD REC
...................................................... 200 mV/2.2 k
Ω
Tone Control
BASS .......................................... ± 6 dB (100 Hz)
TREBLE ...................................... ± 6 dB (10 kHz)
LOUDNESS .... +6.5 dB/+3 dB (100 Hz/10 kHz)
(at volume level –50 dB)
Signal-to-Noise Ratio
(IHF, short circuited, A network)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ......................................... 96 dB
Signal-to Noise Ratio
[EIA, at 1 W (1 kHz)]
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ......................................... 79 dB
+0
– 3
Resetting the main unit
Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver on.
While holding down the TONE button, press
and hold the STANDBY/ON button for about
three seconds.
2 When you see RESET? appear in the
display, press the TONE button.
OK? shows in the display.
3 Press TONE once more to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out well,
and then wipe again with a dry cloth. Do not
use furniture wax or cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this unit,
since these will corrode the surface.
XRE3077A.En.41.48 03.12.4, 7:51 PM 44