Pioneer D514 - Manuel (Page 17)

Connecting up 03
17
En
1/2 inch
Speaker terminals
1 Twist around 1/2 inch of bare
wire strands together.
2 Unclip the speaker terminal
and insert the wire.
3 Snap shut the speaker
terminal to secure.
ª
·
Connecting the speakers
A complete setup of six speakers (including the subwoofer) is shown here, but everyone’s home
setup will vary. Simply connect the speakers you have in the manner shown below. The receiver will
work with just two stereo speakers (the front speakers in the diagram) but using at least three
speakers is recommended, and a complete setup is best for surround sound. If you’re not using a
subwoofer, change the front speaker setting (see Speaker setting on page 32) to large.
Make sure you connect the speaker on the right to the right terminal and the speaker on the left to
the left terminal. Also make sure the positive and negative (+/–) terminals on the receiver match
those on the speakers. You can use speakers with a nominal impedance of 6
Ω to 16Ω (see Switching
the speaker impedance on page 37 if you’re using speakers with an impedance of less than 8
Ω).
Be sure to complete all other
connections before connecting
this unit to the AC power source.
Front Speakers Center Speaker Surround Speakers
Powered subwoofer
FL FR C SR SL
SW
ª
·
The speaker
terminals also
accept single
banana plugs.
VSX-D414 only –
The
SURROUND PREOUT
terminal is intended for use with a
wireless speaker system. See your
wireless speaker manual for more
details on connecting up.
INPUT
R L R L
VSX-D414
XRE3077A.En.12.19 03.12.4, 7:46 PM 17