Pioneer D514 - Manuel (Page 30)

Listening to your system 05
30
En
2 Use the MULTI JOG dial to change the
amount of bass or treble as necessary.
Wait about five seconds for your changes to be
input automatically.
• The tone controls can only be used with the
Stereo sound mode.
• When the receiver is switched to Direct,
using the tone controls automatically
switches the receiver to Stereo mode.
Selecting the multi-channel
analog inputs
Connect a DVD player with 5.1 channel output
to listen to 5.1 channel playback.
• Press DVD 5.1 to listen to the multi-
channel analog inputs.
You can use either the front panel or the remote
control to do this.
• When 5.1 channel playback is selected,
you can’t use the
SIGNAL SELECT, INPUT
ATT, TONE, and MIDNIGHT/LOUDNESS
buttons, as well as the Standard, Advanced
Surround, and Stereo/Direct sound modes.
• When 5.1 channel playback is selected,
only the volume and channel levels can be
set.
Using the sleep timer
The sleep timer switches the receiver into
standby after a specified amount of time so you
can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
INPUT SELECTOR
RECEIVER
CD-R/
TAPE/MD
MIDNIGHT/
LOUDNESS
ADVANCED
SURROUND STANDARD STEREO
SLEEP
DVD/LD
CD FM AM
TV/SAT DVR/VCR DVD 5.1CH
FL DIMMER INPUT ATT
• Press SLEEP repeatedly to set the sleep
time.
Off
90 min 60 min
30 min
• You can check the remaining sleep time at
any time by pressing
SLEEP once. Pressing
repeatedly will cycle through the sleep
options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
XRE3077A.En.26.30 03.12.4, 7:47 PM 30