Pioneer D514 - Manuel (Page 36)

Setting up the receiver 06
36
En
Setting the relative volume
level of each channel
• Default setting: 0 dB
For best surround sound playback, you should
set the relative channel levels from the main
listening position. You can set seperate levels
for each surround mode.
INPUT SELECTOR
RECEIVER
CD-R/
TAPE/MD
MIDNIGHT/
LOUDNESS
ADVANCED
SURROUND STANDARD
TUNER
EDIT
RECEIVER
TOP MENU
DVD
CH SELECT
TEST TONE
SUB TITLE
LEVEL
TUNER
DVD CONTROL
CLASS
MPX DVD
AUDIO DISPLAY TUNING STATION
EFFECT
MUTE
SETUP
STEREO
SLEEP
DVD/LD
CD FM AM
TV/SAT DVR/VCR DVD 5.1CH
FL DIMMER INPUT ATT
MENU
ENTER
VOLUME
1 Press STANDARD.
You can also press ADVANCED SURROUND.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
L C R
LS SW RS
If you don’t hear a test tone from one of your
speakers, please refer to Speaker setting on
page 32 to make sure you have correctly
specified your speaker setup.
3 Press VOLUME +/– to adjust the volume
to an appropriate level.
4 Use LEVEL +/– to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level range
is ± 10 dB.
5 When you’re done, press TEST TONE to
turn off the test tone.
The speaker volume can be adjusted without
outputting the test tone by pressing
CH
SELECT and then using LEVEL +/–. However,
you can only adjust the level of the speakers
currently active in the mode you're listening
to. You can set separate levels for the
STANDARD, STEREO and DVD 5.1 ch
modes, as well as for each
ADVANCED
SURROUND mode.
• Since the subwoofer transmits an ultra-low
frequency its sound may seem quieter than it
actually is.
• Using test tones to set up your speaker
system will overwrite any previous settings
you had for the
STANDARD or ADVANCED
SURROUND modes.
XRE3077A.En.31.36 03.12.4, 7:49 PM 36