Sony MZ-R70 - Manuel (Page 59)

59
-GB
The recorder
does not work
or works
poorly. • The AC power adaptor was unplugged during
recording or a power outage occurred.
• While operating, the recorder received a
mechanical shock, too much static, abnormal
power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Disconnect all the power sources.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
• The disc is damaged or does not contain proper
recording or editing data.
, Reinsert the disc. If this fails, rerecord.
The lid does
not open. • The power sources have been disconnected during
recording or editing, or the battery have been
exhausted.
, Set the power sources again, or replace the
exhausted battery with new ones.
No sound
comes
through the
headphones. • The headphones plug is not firmly connected.
, Plug in the plug of the headphones firmly to
the remote control. Plug in the plug of the
remote control firmly to i1.
• Volume is too low.
, Adjust the volume by pressing VOL +/–.
• AVLS is on.
, Set AVLS to “AVLS OFF” (page 32).
An MD is not
played from
the first track. • Disc playing stopped before it came to the last
track.
, Press . repeatedly or open and close the
lid once to go back to the beginning of the
disc, and restart playing after checking the
track number in the display.
Playback
sound skips. • The recorder is placed where it receives
continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
Symptom Cause/Solution