Warning, Avertissement – Superior SLBV 35/40 Manuel d'utilisation

Page 11

Advertising
background image

11

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

SUPERIOR

®

B-VENT GAS FIREPLACES • MODELS SLBV-35, SLBV-40 • CARE AND OPERATION INSTRUCTIONS

Figure 6

REMOVING AND INSTALLING

THE GLASS ENCLOSURE PANEL

*IMPORTANT!

Bend up the

Top Standoff

Spacers before

installation.

Use outer pair

for 1/2" materials

and inner pair

for 5/8" materials.

Top

Standoff

Spacers*

Control

Compartment

Panel

Hood

Glass

Enclosure

Spring Latch

Panel

Lower

Enclosure Panel

Flush

Nailing

Flange

1/2"

Nailing

Flange

5/8"

Nailing

Flange

WARNING

Any safety screen or guard

removed for servicing the appli-

ance must be replaced prior to

operating the appliance.

AVERTISSEMENT

Tout écran ou protecteur retiré pour

permettre l’entretien de l’appareil

doit être remis en place avant de

mettre l’appareil en marche.

WARNING

Do not attempt to substitute

the materials used on this door

or replace cracked or broken

glass.

Handle this glass with extreme

care! Glass is susceptible to

damage; do NOT scratch or

handle roughly while reinstalling

the glass door frame.

The glass door(s) of this appli-

ance must only be replaced as

a complete unit as provided by

the manufacturer. Do not attempt

to replace broken, cracked, or

chipped glass separately.

Do not attempt to touch the front

enclosure glass with your hands

while the fireplace is in use.

WARNING

Do not operate appliance with

the glass front removed, cracked

or broken.

AVERTISSEMENT

Ne pas utiliser l'appareil si le pan-

neau frontal en verre n'est pas en

place, est craqué ou brisé.

Only doors certified with the appliance

shall be used.

Seules des portes certifiées pour cet

appareil doivent être utilisées.

CAUTION: DO NOT abuse glass enclosure

panel by striking or slamming shut.

This appliance is designed to operate only

when the glass enclosure panel is installed.

Do NOT remove the glass enclosure panel unless

necessary (e.g., to gain access to components

within the firebox or to clean the glass).

Removing the Glass Enclosure Panel

1. Refer to Figure 6. To access the spring

latches securing the front glass enclosure

panel, open the lower control compartment

door by lifting and pulling the bottom panel

forward.

2. Pull the spring latches forward and down to

release them from the lower door channel.

3. Pull the bottom of the glass enclosure panel

out a few inches, and grasp it on the right

and left sides. Gently lift to release the panel

from its upper channel, and then pull the

enclosure panel forward to remove it.

4. Visually inspect the gasket on the backside

of the enclosure panel frame. The gasket

surface must be clean, free of irregularities,

and firmly seated.

Installing the Glass Enclosure Panel

1. Refer to Figure 6. Position the glass enclo-

sure panel in front of the firebox opening,

with the bottom of the enclosure panel held

away from the fireplace. Hook the top flange

of the enclosure panel frame over the top of

the firebox frame.

2. Gently move the bottom of the enclosure

panel frame toward the fireplace, ensuring

that the gasket seats evenly. Fasten the

two latches under the firebox floor to the

vee-flange on the enclosure panel. Close

both latches securely.

Advertising