Jenn-Air Range - Manuel (Page 23)

23
4. Install the Number .038 LP gas oven broil burner orifice hood,
turning it clockwise 4 or 5 turns. Do not overtighten.
5. Place the oven broil burner on the oven broil burner orifice
hood. Insert the oven broil burner locator pin in the hole in the
oven back.
6. Position the oven broil burner against the roof of the oven
cavity and attach with screw.
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
4. Apply masking tape to the end of a
⁹⁄₃₂" (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set Natural gas orifice spud aside.
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the right-hand side
of the bottom oven frame for proper sizing of LP gas orifice
spuds for each burner location.
LP Gas Orifice Spud Chart
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the “LP Gas Orifice Spud Chart.” On dual
burners (on some models), replace the center and outer spuds.
6. Replace burner base and hand tighten the screws.
7. Place LP burner choke into outer hole of dual burner (on
some models).
8. Replace burner cap.
9. Repeat steps 1 through 8 for the remaining burners.
10. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
11. Replace burner grates.
12. Reinstall oven door. See the “Oven Door” section of the Use
and Care Guide.
13. Plug in range or reconnect power.
14. Complete installation. See “Make Gas Connection” and
“Electronic Ignition System” sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
¼" to ½" long. The outer cone is not as distinct as the inner
cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
A. Number .038 LP gas oven broil burner orifice hood
A. Oven broil burner orifice hood
B. Oven broil burner C. Oven broil burner locator pin
D. Oven broil burner locator hole
A. Burner cap
B. Gas tube opening C. Burner base screws
D. Burner base
.038 A
A B
C
D
A
B
C
D
A. Natural gas orifice spud
B. Dual burner
C. Single burner
Location Burner Rating Color Number
Right Front 14,000 BTU Red 114L
Right Rear 4,000 BTU Blue 64L
Left Front 13,000 BTU Center: White
Outer: Orange Center: 55L
Outer: 97L
Left Rear 9,100 BTU Clear 91L
A. LP burner choke
A B C
A