Warning, Install anti-tip bracket, Install downdraft system – Jenn-Air Range Manuel d'utilisation

Page 10

Advertising
background image

10

Install Anti-Tip Bracket

1. Remove the anti-tip bracket that is taped to the package

containing literature.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall
mounting method.

3. Determine and mark centerline of the cutout space. The

mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout
so that right (or left) edge of the bracket is 14

¹⁄₄" (36.2 cm)

from centerline, as shown.

4. Drill two

¹⁄₈" (3.0 mm) holes that correspond to the bracket

holes of the determined mounting method. See the following
illustrations.

5. Using the Phillips screwdriver, mount anti-tip bracket to the

wall or floor with the two #12 x 1

⁵⁄₈" screws provided.

Install Downdraft System

Determine Equivalent Length of Vent System

This range is equipped with a dual range blower. It is shipped
from the factory for Low Range installations. If vent system
equivalent length exceeds 30 ft (9.1 m), the downdraft blower
motor must be converted to High Range for best performance.
See “Calculating Vent System Length” section.

To Convert:

Gently remove the spring loaded Restricter Ring from the blower
inlet by pressing on one of the 3 springs.

Determine which venting method to use: floor, rear wall, or left
side venting. Go to the section for your type of venting.

A. Centerline
B. 14

¹⁄₄

" (36.2 cm)

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation
instructions.

Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed
and engaged.

Failure to follow these instructions can result in death
or serious burns to children and adults.

A

B

Floor Mounting

Wall Mounting

A. #12 x 1

⁵⁄₈

" screws

B. Anti-tip bracket

A. #12 x 1

⁵⁄₈

" screws

B. Anti-tip bracket

A. Restricter ring
B. Spring

A

B

A

B

A

B

Advertising