Jenn-Air Range - Manuel (Page 14)

14
4. Remove 4 locknuts on the motor side of the blower and
remove the bracket.
5. Lift and rotate the motor 180° to reposition the electrical
connection.
6. Rotate bracket 90° and secure with 4 locknuts.
7. Remove the bracket from the other side of the blower motor,
rotate 90° and secure with 4 locknuts.
8. Mount blower motor to floor using 4 - #8 x ¾" hex head
screws provided.
NOTE: Vent system will be connected after range has been
moved into its final location. See the “Connect Range to
Downdraft System” section.
9. Go to the “Make Gas Connection” section.
View from Motor Side of Blower
A. Electrical connector
A. Electrical connector
A
A
Top View
A. 2
⁷⁄₈
" (7.3 cm) from back wall
to edge of bracket
B. Mounting bracket
C. Blower
A
B
C