Jenn-Air Range - Manuel (Page 21)

21
To Convert Gas Pressure Regulator
1. Remove access panel by grasping sides and pulling upward,
lifting out.
2. Locate gas pressure regulator behind access panel.
IMPORTANT: Do not remove the gas pressure regulator.
3. Unscrew the regulator cap and remove the plastic cover.
4. Flip the regulator cap over and replace the plastic cover.
5. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Oven Bake Burner
1. Remove oven racks from inside the oven cavity.
2. Remove the oven door. See “Oven Door” section in the Use
and Care Guide for oven door removal instructions.
3. Using a Phillips screwdriver, remove and set aside the 2 oven
bake burner cover screws located at the front of the oven.
4. Lift up and remove oven bake burner cover.
5. Unscrew 2 wing nuts and remove oven baffle.
6. Using a Phillips screwdriver, remove and set aside the 2 oven
bake burner screws and the orifice hood cover screw.
7. Lift up and remove orifice hood cover.
8. Lift up and remove oven bake burner.
A. Gas pressure regulator
A. Plastic cover
B. Regulator cap
A. Natural gas position
B. LP gas position
C. Plastic cover
A
A
B
A
B
C
A. Oven bake burner cover
B. Oven bake burner cover screws
A. Oven baffle
B. Wing nuts
A. Oven bake burner screws
B. Orifice hood cover C. Orifice hood cover screw
D. Oven Bake burner
A
B
A
B
A
B
C
D