Location requirements, Installation clearances, Washer dimensions – Maytag MHWZ600WR Manuel d'utilisation

Page 6

Advertising
background image

6

Location Requirements

Selecting the proper location for your washer improves performance and minimizes noise and
possible washer “walk.”
Your washer can be installed under a custom counter, or in a basement, laundry room, closet,
or recessed area. See “Drain System.”
Companion appliance location requirements should also be considered. Proper installation is
your responsibility.
You will need

„

A water heater set to deliver 120°F (49°C) water to the washer.

„

A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is
attached to the back of the washer. See “Electrical Requirements.”

„

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves,
and water pressure of 20-100 psi (137.9-689.6 kPa).

„

A level floor with a maximum slope of 1" (25 mm) under entire washer. Installing the
washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not
recommended.

„

A sturdy and solid floor to support the washer with a total weight (water and load) of
400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the
washer and can cause damage in low temperatures. See “Washer Care” for information on
winterizing.

Installation clearances

„

The location must be large enough to allow the washer door to be fully opened.

„

Additional spacing should be considered for ease of installation and servicing. The door
opens more than 90°, and it is not reversible.

„

Additional clearances might be required for wall, door, and floor moldings.

„

Additional spacing of 1" (25 mm) on all sides of the washer is recommended to reduce
noise transfer.

„

Companion appliance spacing should also be considered.

Washer Dimensions

27"

(686 mm)

50¼"

(1276 mm)

36"

(914 mm)

30½"

(775 mm)

Door is not reversible.

Recommended installation spacing for custom undercounter installation

The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only

1"

(25 mm)

1"

(25 mm)

37" min.

(939 mm)

27"

(686 mm)

Recommended installation spacing for recessed or closet installation, with or without

a pedestal

The dimensions shown are for the recommended spacing.

Advertising
Ce manuel est liée aux produits suivants: