Breville DIE CAST PROGRAMMABLE BES820XL - Manuel (Page 14)

14
water tank storage area. Do not touch or
try to remove this tube, it will
automatically slide back into position
when the water tank is re inserted.
• Fill the water tank with cold, tap water to
the maximum mark on the water window
and slide the water tank carefully back
into position in the machine.
• Ensure the Selector Control is in the
‘Standby’ position and plug the power
cord into a 110/120V power outlet and
switch on.
• Press the POWER button to ‘On’, the
POWER button surround will flash while
the machine is heating. When the
correct temperature has been reached,
all the button surrounds on the control
panel will illuminate.
New close up photo of 1 cup
button on control panel
STEp 1 - FILLINg THE WATER TANK
• Ensure the Power is off and the Selector
Control, on the side of the machine, is
set to the Standby position.
• Switch the machine off at the power
outlet and unplug the power cord.
• Remove the filter holder if locked into the
brew head and move the steam wand to
the side of the machine.
• Remove the water tank by sliding out
using the handle insert in the front of the
water tank.
• As the water tank is removed, a black
tube slides and extends out from the
STEp 2 - pRE-WARMINg THE CupS
• The Cup Warming Plate will start to
warm as the machine heats.
• Pre-warm the espresso cups by placing
on the Cup Warming Plate. This will help
maintain the coffee’s optimal
temperature when brewed into the cups.
OpERATINg YOuR BREVILLE DIE CAST pROgRAMMABLE ESpRESSO MACHINE
NOTE: Check the water level before use
and replace the water daily. The
water tank should be refilled
with fresh, cold tap water before
each use. Do not use mineral or
distilled water or any other liquid.