Napoleon Fireplaces GDI44 - Manuel (Page 14)

14
W415-0734 / D / 02.03.12
The appliance can be
equipped with either a 3- or
4-sided trim kit to fi nish off
the fi replace opening. Slide
the trim assembly over the
keyholes (2 per side) and
drop into place. If installing
the optional 3- or 4-sided
backer plate (GDIBP3 or
GDIBP4), it must be hung
prior to the trim kit installation
using the same keyholes.
TO ADJUST THE TRIM:
If the mitre is out of alignment, open each side and loosen the two screws at
either side trim hinge. Slide the trim up or down to adjust and re-tighten screws.
There is also a very slight in/out adjustment that can be made.
NOTE: Since the side panels open and close, to access the controls, a gap
is necessary at the mitre joint.
The top trim piece has an adjustable securing bracket which enables the trim to
be secured to the fi rebox shell.
4.5 ALUMINUM EXTRUSION TRIM KIT INSTALLATION
LOOSEN
SCREWS
SLIDE TO
ADJUST
In order to close off the fi replace opening or if the opening is larger than the 3- or 4-sided aluminium extrusion
trim kits, it is recommended to reduce the opening using a noncombustible material such as ceramic tile, mar-
ble, etc or the GDIBP3 or GDIBP4 backer plate kits. The GDIBP3 backer plate is able to fi t an opening of 52" x
33½". The GDIBP4 backer plate is able to fi t an opening of 52" x 42¾". The outside edge of the backer plate is
fi nished off with gold trim included in each kit. A GDIBP3D 3 sided deluxe backer plate complete with marquis
trim may also be used to complete the installation
. This kit is able to fi t an opening of 57" x 33½". Detailed
installation instructions are included with each kit.
If this appliance is being installed into an existing wood burning, zero clearance fi replace, then be aware of this
precaution: Any circulation air opening may be covered (with material) but not sealed!