Napoleon Fireplaces Vector 62 - LHD62 Manuel d'utilisation

Page 48

Advertising
background image

W415-1068 / B / 01.02.14

48

EN

A.

Remove the media tray by removing all screws securing the front, rear and side panels.

B.

For upper latches

: locate the latch you need to replace, ensure to keep a grip on the latch. Begin

removing the 4 screws securing it in place from the inside of the fi rebox, pull latch forward. Install new
latch and ensure it remains secure by tightening the 4 screws.

C.

For lower latches

: locate the latch you need to replace, ensure to keep a grip on the latch. Begin

removing the 4 screws securing it in place from the inside of the fi rebox, pull latch forward. To install
the new latch secure the 2 rear screws prior to securing the 2 front screws.

D.

Ensure proper door seal.

*Prior to replacing the latches follow the “DOOR REMOVAL” process and then follow the media removal
instructions located under the maintenance section.

A.

Remove the 2 screws on either top side of the rear porcelain panels.

B.

Pivot the panel forwards and lift out, as shown below.

C.

Remove the 4 screws on both top and bottom of the side porcelain panels

D.

Pivot the panel forwards and lift out, as shown below.

11.6 NIGHT LIGHT REPLACEMENT

Your appliance came equipped with our “NIGHT LIGHT”. The light has been
pre-wired and can be controlled by remote control.

It is recommended that the NIGHT LIGHT be in the off position when the
appliance is on.

If in the event the lamp or lens needs to be replaced, follow the
instructions below.
A.

Shut off the electrical supply to the fi replace.

B.

Remove the four screws that secure the lens frame. This frame

retains the glass lens. The lamp can now be accessed.

NOTE: Do not handle the lamp (bulb) with bare fi ngers,
protect with a clean dry cloth.
C.

The lamp will pull straight out of the socket.

Replace with Wolf Steel parts only, as lamp and lens are

special “high temperature” products.

D.

When re-installing, ensure integrity of gasket seal.

THE FIREBOX MUST BE SEALED.

NOTE: Over tightening the screws could break the lens.

SCREWS

LENS ASSEMBLY

FIREBOX TOP

GASKET

LENS

FRAME

AMBER

SIDE UP

11.7 PORCELAIN PANEL REMOVAL

11.8 DOOR LATCH REPLACEMENT

Advertising