Bosch HBLP751UC - Manuel (Page 9)

English 6
Oven Bottom
The oven bottom conceals the lower heating element. As a
result the element is protected from damage and spills.
Note:
Do not place food directly on the oven bottom.
Accessories
Inserting Racks
Flat Rack
The rack is designed with a stop so it will stop before
coming completely out of the oven and not tilt.
To insert the flat rack into the oven:
Note: Avoid pushing the rack back forcefully, impacting the
rear of the oven cavity. Risk of damage to porcelain coating
or to glass covers over light fixtures.
1. Grasp rack firmly on both sides.
2. Insert rack (see picture).
3. Tilt rack up (A) to allow the upwardly sloped rear of the
rack to slide under the stop molded into the front
portion of the rack guide above.
4. When the back of the rack is past this stop, lower the
front of the rack to a horizontal position (B) and push it
the rest of the way in.
The rack should be straight and flat, not crooked.
9 CAUTION
Do not use aluminum foil or protective liners to line
any part of the appliance, especially the oven
bottom. Installation of these liners may result in a
risk of electric shock or fire.
Probe
The probe can be used to
determine the internal
doneness or the end
temperature of many
foods, especially meats
and poultry.
Do not clean in the self
clean oven or dishwasher.
Flat Rack
Use for most cooking. Can
use multiple racks in some
modes.
Do not clean in the self
clean oven.
Telescopic Rack
Use with heavier dishes to
make it easier to put
dishes into the oven,
check on while cooking
and remove dishes from
oven when done.
Do not clean in the self
clean oven.
9 CAUTION
To avoid burns, place oven racks in desired
positions before turning oven on. Always use oven
mitts when the oven is warm. If a rack must be
moved while the oven is hot, do not let oven mitts
contact hot heating elements.
Use caution when removing an oven rack from the
lowest rack position to avoid contact with the hot
oven door.
To avoid possible injury or damage to the appliance,
ensure racks are installed exactly per installation
instructions and not backwards or upside down.