Bosch HBLP751UC - Manuel (Page 17)

English 14
To use the probe:
1. Insert the probe into the meat as described above.
2. Connect the probe to the oven. If the probe is not
connected to the oven prior to starting Probe mode, an
error tone sounds.
3. Press the Auto Probe touchpad. Use the soft keys at
the bottom of the display to select screens to enter the
desired food temperature, the oven mode to use and
the oven temperature. Use the numeric keypad to enter
the desired values. Press Enter on the numeric keypad
to confirm the settings and to start the probe mode.
Note: The minimum probe temperature that can be set
is 100° F (38° C) and the maximum is 450° F (232° C).
If the probe temperature entered is outside this range,
an error is displayed.
The displayed probe temperature is updated in
increments of 5° during the cooking process.
When the probe temperature reaches the set
temperature, the cooking mode turns off and an alarm
tone sounds every 10 seconds for 2 minutes.
This screen remains in the display until it is cleared by
pressing the Oven Clear/Off touchpad or until the
probe is removed. The display then goes back to Stand
By mode.
Note:
•
Probe is not available when a Oven Timer has been
set.
• To change the probe temperature press the probe
Auto softkey. The display enters probe temperature
editing mode and displays the message “SET PROBE
TEMP”. Enter the new probe temperature and press
Enter to accept the new value.
• Do not store the probe in the oven.
• Always use the handle of the probe for inserting and
removing.
• Always use a potholder to remove the probe since it
becomes hot.
• The probe is only available for the upper oven in
double oven units.
Eco Chef
The Eco Chef program uses residual heat to reduce energy
consumption during cooking. Eco Chef uses the meat
probe and is suggested for beef roasts, pork roasts, whole
poultry and lamb roasts.
To use Eco Chef:
1. Insert the probe.
2. Press the Eco Chef touchpad.
3. Select the meat and doneness.
4. Enter the desired cooking termperature.
5. Press Start.
The door must not be opened during the residual heat
stage of Eco Chef.
The oven will monitor the internal temperature of the meat.
When the meat is ready, the unit sounds an alarm tone.
Sabbath Mode
The Sabbath mode enables those of particular faiths to use
their ovens on the Sabbath.
The Sabbath mode can be entered in a bake cycle only.
The bake temperature must be within the Sabbath mode
temperature range of 100° to 450° F. Once the Sabbath
mode has been started the cooking temperature can be
changed (within the Sabbath mode allowable temperature
range) by using the numeric keypad and pressing Enter to
confirm the new temperature. There is no visual or audible
response to input and there is a 30 second delay before
the new temperature is activated.
If the oven light is on during setup, it remains on throughout
the Sabbath mode operation. If the oven light is off during
setup, it remains off throughout the Sabbath mode
operation.
To set the Sabbath mode:
1. No kitchen timers or oven timers may be running when
Sabbath mode is entered. The probe must not be
inserted.
The Bake mode must be running (or in the process of
being set up to run). Press the Oven Timer soft key for
five seconds.
If a timer is running or the probe is inserted or the
temperature set is outside the acceptable Sabbath
mode range when Sabbath mode attempts to startan
error tone will sound
If no timers are running, the Sabbath mode display is
shown.