Onkyo HT-R980 - Manuel (Page 67)

67
En
■
Can’t record
■ There’s no sound
■
The Zone 2 speakers produce no sound
■ Stand-by power consumption
■ The sound changes when I connect my
headphones
■
The speaker distance cannot be set as required
■ How do I change the language of a multiplex
source
■ The functions don’t work
■
The functions System On/Auto Power On and
Direct Change don’t work for components
connected via
■
When performing “Audyssey 2EQ ® Room
Correction and Speaker Setup”, the
measurement fails showing the message
“Ambient noise is too high.”.
■ The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
source that you want to set, press SETUP.
2. Use / to change the setting.
3. Press the input selector button for the input source that you
want to set when you’ve finished.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
CBL/SAT, GAME, or AUX input.
If you have a games console connected to the composite
video input, and the picture isn’t very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.
To control an Onkyo component that’s not connected
via
, point the remote controller at the compo-
nent. Be sure to enter the appropriate remote control
code first.
61
The entered remote control code may not be correct.
If more than one code is listed, try each one. —
Recording
On your recorder, make sure the correct input is
selected. —
To prevent signal loops and damage to the AV
receiver, input signals are not fed through to outputs
with the same name (VCR/DVR IN to VCR/DVR
OUT). —
Zone 2
Only components connected to analog inputs can be
played in Zone 2. —
To use the Zone 2 speakers, you must set the “Front
High/Zone2” setting to “Zone2”. 54
Others
In the following cases, the power consumption may
reach up to a maximum of 50W:
1.
You are using the Universal Port jack.
2. “HDMI Control (RIHD)” setting is set to
“On”. (Depending on the TV status, the AV
receiver will enter Standby mode as usual.)
49, 56
When a pair of headphones is connected, the listen-
ing mode is set to Stereo, unless it’s already set to
Stereo, Mono, or Direct. —
In some cases, corrected values suitable for home
theater use may be set automatically. —
Use the “Multiplex” setting on the “Audio Adjust”
menu to select “Main” or “Sub”. 42
To use , you must make an connection and an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
17
These functions don’t work when Zone 2 is turned
on. 17
This can be caused by any malfunction in your
speaker unit. Check if the unit produces normal
sounds. —
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.