Roland DIGITAL STUDIO WORKSTATION VS-2480 - Manuel (Page 18)

18
Preparations
fig.battery3_69
7. Reinstall the effect expansion board (VS8F-2) if removed in Step 5. Insert
the plastic pin in the VS8F-2’s hole, making sure the board is securely
fastened in place.
8. Use the screws that you removed in step 2 to fasten the cover back in place.
This completes the process of exchanging the lithium battery.
9. Connect the cables that you disconnected earlier.
10. Turn on the power, as described in “Turning On the Power (p. 19).”
11. Confirm that the message warning that the lithium battery is depleted does
not appear in the display.
12. Set the current time (p. 22).
Basic Connections (Power Supply, Audio
Devices and Headphones)
fig.01-11j_60
If you are using headphones, connect them to the rear panel PHONES 1 or PHONES
2 jack. The PHONES jack will output the same signal as the MONITOR jacks.
When you purchase the VS-2480/2480CD, it will be set so that all analog audio
signals are output from the MASTER jacks. The MONITOR jacks will output the
same sound as the MASTER jacks.
fig.01-12
A CR2032 lithium battery is
used for the
VS-2480/2480CD. This type
of battery is available at an
electric appliance, or
similar store.
The internal clock is
powered by the lithium
battery. Changing the
lithium battery may cause
this clock to stop, or may
result in the current time
being altered. Always
make sure to newly set the
correct time after the
lithium battery has been
replaced.
For details refer to Owner’s
Manual “Working with the
VS-2480 Output. (p. 287)”
Stereo Set, etc.
Stereo Headphones
(RH-25, RH-50, etc.)
WORD CLOCK IN VGA OUT SCSI
POWER
ON
AC IN R L R L R L
FOOT SWITCH
MONITOR AUX A AUX B
3 4
R L MASTER
1 2 5 6 7 8 PHONES 1 PHONES 2
ANALOG MULTI OUTPUT KEYBOARD SMPTE IN MOUSE MIDI IN OUT / THRU PS / 2
OUT IN OUT IN
DIGITAL
OPTICAL 2 COAXIAL
THIS DEVICE COMPLIES WITH PART 15 OF TO THE FOLLOWING TWO CONDITIONS: THE FCC RULES. OPERATION IS SUBJECT (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
DIGITAL 8ch I / O DIGITAL 8ch I / O 1
+4dBu BALANCED / -2dBu UNBALANCED
(TIP)
(RING) (SLEEVE) HOT
COLD GND
To Power Outlet Ground (Earth)