Roland DIGITAL STUDIO WORKSTATION VS-2480 - Manuel (Page 29)

29
Listening to the Demo Performance
Listening to the Demo
Performance
3. Press [F6 (To Pre)] to select pre level display, and press [F6 (To Pst)] once
again to select post level display, alternately (except from the INPUT
display or OUTPUT display).
The upper part of the level meter will indicate whether the current display is the pre
level or the post level.
When pre level display, since this shows the volume levels before the signal passes
through the channel faders, the level meter display will not change when you
operate the channel faders.
When post level display, since this shows the volume levels after the signal passes
through the channel faders, the level meter display will be affected when you
operate the channel faders.
fig.02-05
■ Adjusting the Overall Volume
To adjust the overall volume of the performance, use the MASTER fader or the
MONITOR knob.
■ Adjusting the Volume of an Individual Track
To adjust the volume of an individual track press [TR 1-16 (MASTER EDIT)], so that
the [TR 1-16 (MASTER EDIT)] indicator will light, and use the channel faders.
If you wish to adjust the track of channel 17–24, press [TR 17-24 / FX RTN
(V.FADER)]
, so that the [TR 17-24 / FX RTN (V.FADER)] indicator will light, and use
the channel faders.
■ Adjusting the Headphone Volume
To adjust the volume of the headphones, use the PHONES 1 or the PHONES 2 knob.
The MONITOR level and
MASTER level are always
displayed as Post level.
For details refer to “Mixer
Section Block Diagram”
(accessory sheet).