Roland DIGITAL STUDIO WORKSTATION VS-2480 - Manuel (Page 19)

19
Preparations
Preparations
Be sure to ground the device to prevent any minor leakage of current from the
VS-2480/2480CD, connectors, or other possible sources.
Turning On the Power
1. The rear panel POWER switch
turns on the power of the
VS-2480/2480CD. Use the rear
panel POWER switch to turn on the
power of the VS-2480/2480CD. The
current system version number will
be displayed with the opening
screen. Please wait.
fig.01-13
2. When the VS-2480/2480CD starts
up correctly, the following display
(Home Condition screen) will
appear.
3. Turn on the power of your audio
system.
4. Raise the volume of your audio
system to an appropriate level.
Always make sure to have the volume level turned down before switching
on power. Even with the volume all the way down, you may still hear some
sound when the power is switched on, but this is normal, and does not
indicate a malfunction.
To prevent malfunction
and/or damage to speakers
or other devices, always
turn down the volume
before making any
connections.
The VS-2480/2480CD Support the “Mouse” and
the “VGA Monitor”
The VS-2480/2480CD has a “Mouse connector” that allows a mouse to be connected.
If a mouse is connected, you will be able to use a mouse to operate the buttons and
control knobs that appear in the display of the VS-2480/2480CD.
If a personal computer VGA monitor is connected to the “VGA connector,” you can
view your operations on a larger screen than the display built into the
VS-2480/2480CD
Do not connect a mouse to
the keyboard connector. It
becomes the cause of
malfunction.
System Version #
When the power is turned
on, the disk drive will be
detected, and necessary
data will be read. For this
reason there will be an
interval of time before
operation can begin.
Once the connections have
been completed (p. 18),
turn on power to your
various devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.