Roland DIGITAL STUDIO WORKSTATION VS-2480 - Manuel (Page 59)

59
Using Effects
Using Effects
Applying a Loop Type Effect While You
Record
Here we will give an example of how a loop type effect such as reverb can be applied
to the source of the INPUT 1 jack, and the direct sound and effect sound recorded
together on track 3. This is the method you will use when, for example, you wish to
apply reverb to a vocal and record both the direct sound and effect sound together.
fig.04-13_60
1. Press [HOME (DISPLAY)]. Home
Condition screen will appear.
2. As described in “Selecting the
effect bus assignment
(p. 52),” specify which AUX bus will be used as the
effect bus.
fig.04-15_30
3. Press [IN 1-16 (SOLO)]. [IN 1-16 (SOLO)] indicator will light, channel
fader will adjust the Input Mixer channel 1–16 level.
4. Raise and lower the channel fader 1, and verify that the volume changes.
The Input Mixer channel fader is used to make fine adjustments to the
recording level. In order to record with optimal audio quality, the fader
should normally be set in the 0 dB position.
5. Press [TR 1-16 (MASTER EDIT)]. [TR 1-16 (MASTER EDIT)] indicator will
light, [CH EDIT] will be the Track Mixer edit buttons for channel 1–16.
6. Hold [REC] and press [TRACK STATUS] of
the track that you wish to record. For this
example, hold [REC] and Track Mixer
channel 3 [TRACK STATUS]. Track 3 will be recording track, and [TRACK
STATUS]
indicator will blink red.
PAGE F1 F2 F3 F4 F5 F6 HOME
DISPLAY
TRACK STATUS / PHRASE PAD
IN 1-16
SOLO
9 12 1
17
2
18
3
19
4
20
5
21
6
22
7
23
8
24 MASTER
(dB)
6
4
0
4
8
12
18
24
42
(dB)
6
4
0
4
8
12
18
24
42
TO
FROM
13 14 15 16 10 11
FX 2 FX1 FX 3 FX 4 FX 5 FX 6 FX 7 FX 8
AUX 2 AUX1 MST AUX 3 AUX 4 AUX 5 AUX 6 AUX 7 AUX 8
PAN / AUX SEND 1-8
CH EDIT / SELECT / PHRASE SEQ STATUS / AUTOMIX STATUS
FX RTN
IN 17-24
AUX MST
TR 17-24 TR 1-16
Q Q RATIO GAIN FREQ FREQ GAIN FREQ GAIN GAIN FREQ THRESHOLD ATTACK RELEASE LEVEL FREQ
EQ Low EQ High
FADER
WRITE
READ
MANUAL
PRM
MUTE
EQ Lo - Mid EQ Hi - Mid Dynamics
RTN
PHRASE
REC
PLAY
OFF
TRACK
PHRASE SEQ
MASTER EDIT
V.FADER
EDIT
PHRASE
PAD PLAY
AUX
SEND
PHRASE SEQ
PAD
/ AUTOMIX
Filter
L
R
L
R
3,9
4 15
14
5
10
3
+
AUTOMIX REC
REC
The remaining time for
recording is displayed in
the upper right of the home
condition screen. Consider
these numbers as
approximate values. In
addition to the remaining
time, the display can also
be switched to remaining
capacity (MB units,
percentage (%), or event
units).