Roland DIGITAL STUDIO WORKSTATION VS-2480 - Manuel (Page 12)

12
Preparations
fig.01-08_50
3. Inside, there are four connectors and 12 resin pins. Insert the connectors of
the VS8F-2 in to the internal connectors, and simultaneously insert the resin
pins into the holes of the VS8F-2 to fasten the unit in place.
4. Use the screws that you removed in step 2 to fasten the cover back in place.
This completes installation of the effect expansion board.
5. Connect the cables that you disconnected earlier.
6. Turn on the power, as described in “ Turning On the Power (p. 19).”
7. After proper startup of the VS-2480/2480CD, press [EFFECT] and confirm
that the FX 1 and 2 icons are displayed. If two VS8F-2 units are installed,
press [EFFECT] and confirm that the icons for FX 1–4 are displayed.
EFFECT B
EFFECT C
EFFECT D
EFFECT A
When turning the unit
upside-down, get a bunch
of newspapers or
magazines, and place them
under the four corners or at
both ends to prevent
damage to the buttons and
controls. Also, you should
try to orient the unit so no
buttons or controls get
damaged.
When turning the unit
upside-down, handle with
care to avoid dropping it,
or allowing it to fall or tip
over.
Install VS8F-2 effect
expansion boards in the
order of EFFECT A,
EFFECT B, EFFECT C, and
EFFECT D. Do not skip
slots when installing these
boards.
The VS-2480/2480CD
comes equipped with one
internal effects expansion
board (containing two
effects processors).