Husky POWERWASHER 1800 CA - Manuel (Page 26)

26
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Wand is malfunctioning Test both wands to ensure that one is not mal-
functioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
Wand - Attaching To attach the Wand apply some moderate
downward pressure on the Wand (In the direc-
tion of the trigger) while simultaneously twisting
the wand a 1/4 of a turn clockwise. It may help
if you set the gun vertically on a flat surface with
the wand pointing upwards. The two tabs on the
end of the Wand must slide all the way in before
the Wand will twist and lock. If this does not work
remove the o-ring from the end of the wand and
attach it without the o-ring. If the wand attaches,
you will need to replace the o-ring. Contact us at
customerservice@huskypowerwasher.
com
or order a replacement directly online at
www.huskypowerwasher.com .
Wand - Removing Release the back pressure in the Gun/Hose. Re-
move the Garden Hose from the unit and squee-
ze the trigger of the Gun. Apply some moderate
downward pressure on the Wand (In the direc-
tion of the trigger) while simultaneously twisting
the wand a 1/4 of a turn counterclockwise. (It
may help if you set the gun vertically on a flat
surface with the Wand pointing upwards). For
additional assistance you can email us at custo
[email protected].
Wand - Gray collar won’t
turn/won’t adjust to low/
high pressure
To turn the gray collar, hold the Wand hori-
zontally in both hands. Hold the collar firmly
in one hand and the shaft of the Wand in the
other hand. It works best if you grab the shaft
by the “beehive” shaped portion at the bottom
of the Wand. Sometimes the gray collar gets
tightened down too far and needs some extra
force to move it. For additional assistance you
can email us at customerservice@huskypo
werwasher.com.