Baby Lock Jane (BL500A) Instruction and Reference Guide - Manuel (Page 16)

10
Threading (2)
Note Please turn off the power before using needle threader. Accidentally stepping on the foot controller during this operation could cause bodily injury or damage to the machine.
1 Rotate hand wheel towards you until
needle is in the highest position, and
lower presser foot.
2 Take thread in your left hand, and
gently pull it forward.
3 Lower needle threader.
✽ Pull thread along the right side of the pin.
✽ Do not force the needle threader lower
than the eye of the needle. Be sure that
the needle is in the highest position.
4 Turn the needle threader lever all
the way in the direction of 1 and
when the hook extends from the
needle hole, pull the thread in the di-
rection of
2 to catch it on the hook.
5 While holding the thread gently, return
the needle threader lever to the right. As
you do this the hook that has caught the
thread will move as well, pulling a loop
of thread through the eye of the needle.
Using the Needle Threader
1
2
6
7
8
9
0
A
3
4
5
Long
Groove
Depression
Thread
Needle Hole
1
2
3
5
6
4
7
8
9
0
A
● Make sure thread take-up lever is in
highest position and presser foot is up.
✽ When using polyester thread or thread
that tangles or breaks, run the thread
through all Three Hole of the thread guide.
✽ If the thread is still
tangles or breaks, run
the thread through the
holes backwards as
shown in diagram.
Pin
Thread
1
2
Hook
Automatic
Needle
Threader
✽ Pull the thread to
the left and check
that it is caught on
the hook.
Upper Threading