Baby Lock Jane (BL500A) Instruction and Reference Guide - Manuel (Page 13)

2
3
4
1
3
1
2
Spool of Thread
✽2
Spool Cone Holder
Spool Cap
✽1
Threading (1)
Note
Do not move bobbin winding clutch while machine
is running.
Bobbin Winding
1 Raise the thread guide bar all the way.
2 Mount a spool thread on the spool pin.
✽1 Use spool cap when using parallel-wound thread.
✽2 Use spool cone holder to stabilize cone shaped spools of thread.
3 Pass the thread through the triangu-
lar hole.
4 Pass thread through bobbin winding
thread guide as shown in drawing.
5 Run thread through top thread notch
1, and align bottom thread notch 2 of
the bobbin with guide pin on bobbin
winder shaft.
6 Press bobbin winding clutch up
against empty bobbin. If the bobbin
stop does not slide easily between
the top and bottom of the bobbin,
check that the bobbin is seated prop-
erly with the guide pin (5) inserted
into the lower notch.
Bobbin
Bobbin Winder
Shaft
Guide Pin
Thread Notch 1
Thread Notch 2
Bobbin Winding Clutch
5 - 0: See the following illustrations.
7