Baby Lock Jane (BL500A) Instruction and Reference Guide - Manuel (Page 14)

9 Manually move bobbin winding clutch
back to original position.
0 Cut thread and remove bobbin. 7 While holding the end of the thread, step on
the foot controller for a few seconds. Once
enough thread has wound itself around the
bobbin to hold itself in place, release the
foot controller and trim the excess thread.
Continue to wind the bobbin while pressing
down on the foot controller.
8 Release the foot controller to stop
winding process when bobbin is full.
✽
Place the thread end so that it does
not protrude from the bobbin.
Bobbin Winding Clutch
8