Denon DN-S3500 - Manuel (Page 8)

2
ENGLISH
ENGLISH
2 INSTALLING THE PLATTER, THE SCRATCH DISC AND
THE SLIPMAT / CONNECTIONS (2) CONNECTIONS
1. Turn off the POWER switch.
2. Connect the RCA pin cords between the DN-S3500 outputs and inputs of your mixer.
3. If your mixer has Fader Start function such as our DENON Mixer, connect FADER jack to the mixer using 3.5
mm stereo mini cord.
POWER ON OFF
DIGITAL OUT
L
R
LINE OUT FADER IN OUT MEMO
L
L
L
L R
L
R
L
LINE1
FADER
PGM 1
FADER
LINE
OUT
(3) INSTALLATION
Please set up DN-S3500 horizontally.
(4) INSTALLING THE 7” (17cm) RECORD ADAPTOR
Your own 7” (17cm) vinyl record can be installed on this product by using the provided adaptor.
This original design grants you the freedom to use your favorite vinyl record for that ultimate analog turntable
feel.
*Make sure the record used is flat and not warped.
• 7” (17cm) record adaptor accessories
q Adaptor (2) ........................................................1
w Screw (< head) ................................................3
e Fixing Plate .......................................................1
DN-X300
(1) INSTALLING THE PLATTER, THE SCRATCH DISC and THE SLIPMAT
• Accessories 1. Install the Platter on the taper boss of the motor.
2. Install the Slip Mat on the Platter.
3. Insert D hole of the Scratch Disc on the D shaft of
the Motor.
NOTE: The printed face is located on the Slip Mat
side.
4. Insert the Adaptor according to the direction of the
arrow.
NOTE: Please note the direction of insertion.
NOTE:
Depending on the RECORD you choose, friction
with the Slipmat may not be enough, which can
cause an undesired drag sound.
If so, use a different record that’s thicker or
heavier.
1. Set Adaptor (2) in the hole of 7” record.
2. Fix Plate with 3 screws. (< head).
3. Insert D hole of the Adaptor (2) on the D shaft of the
Motor.
4. Insert the Adaptor (1) on the Adaptor (2).
q Aluminum Platter..............................................1
w Scratch Disc......................................................1
e Slip Mat ............................................................1
r Adaptor (1) ........................................................2
(One is for spare parts.)
Scratch Disc
(Groove side
DOWN)
D shaft
Slip Mat
Platter
Taper Boss
(Motor Unit)
Fig. 1 Scratch Disc
Adaptor (1)
Fig. 2
Fig. 3
Screw (< head)
Fixing Plate
7” (17 cm) record
Adaptor (2)
Fig. 1
Fig. 2
7” (17cm) Disc
Adaptor (2)
Adaptor (1)
Slip Mat
Adaptor (1)
CAUTIONS:
• Do not touch the motor unit.
• Do not turn on the power without Platter. NOTE:
Please note the fall of Platter when you move DN-
S3500 after Platter is set.