Ppendix, Isassembly, Eassembly – Labconco Protector Pass-Through Laboratory Fume Hoods 1136 Series Manuel d'utilisation
Page 57: Nstructions
Product Service 1-800-522-7658
53
Original instructions
A
PPENDIX
F
D
ISASSEMBLY
AND
R
EASSEMBLY
I
NSTRUCTIONS
Required Tools
The following tools will be required for disassembly and reassembly:
Cordless Drills and Phillips bits.
1/4", 5/16", 3/8", 7/16" Sockets
Small Screwdriver
Phillips Screwdriver
Right Angle Screwdriver
1/4", 5/16" Box Ratchet
1/4" Extension
5/16", 3/8", 7/16" Combination Wrench 1/4" Ratchet
Small Right Angle Needle Nose Pliers Nut Driver Set
Decorative Panel Removal
1. Remove side panels by removing #10-24 screws and lifting away.
2. Remove front panels by lifting up and away.
Blower Wiring
1. All the removable wires are part of the wiring harness to the corner post switches. Be
sure to label all wires and refer to the wiring diagrams for proper reassembly.
Header Removal
1. The header panels are fastened to the corner posts by four #12 screws each. Simply
reach behind the corner posts from the side and remove the screws while another
person supports the header.