Labconco Protector Pass-Through Laboratory Fume Hoods 1136 Series - Manuel (Page 37)

Chapter 7: Modifying Your Protector Pass-Through
Product Service 1-800-522-7658 33
Original instructions
9571101 Service Fixture GAS, mid-lower right, Pos. 2
9571102 Service Fixture GAS, mid-upper right, Pos. 3
9571103 Service Fixture GAS, upper right, Pos. 4
9571104 Service Fixture GAS, lower left, Pos. 1
9571105 Service Fixture GAS, mid-lower left, Pos. 2
9571106 Service Fixture GAS, mid-upper left, Pos. 3
9571107 Service Fixture GAS, upper left, Pos. 4
Note: Any fixture can be converted to Air, Vacuum, etc. See Appendix A of this
manual.
Installing Guardian™ Digital Airflow
Monitor or Guardian™ Airflow Monitor
The Guardian Airflow Monitors continuously monitor face velocity through the
fume hood opening. The fume hood right corner post is factory prepared to
mount either monitor. Contact Labconco Customer Service to order.
Guardian Digital Airflow Monitors
9413400 100-115V, 50/60 Hz Digital
9413401 208-230V, 50/60 Hz Digital
Guardian Airflow Monitors
9413300 100-115V, 50/60 Hz Analog
9413301 208-230V, 50/60 Hz Analog
Note: Order the following for proper installation with Pass-Through Hoods
9571300 Kit, Guardian AFM Extension, Pass-Through
Sash Stop Kit – Field Installation
P/N 9410300
The sash stop kit restricts how far a vertical-rising sash may be opened. This
small plastic device may be easily field installed on the fixture corner post of any
fume hood.