Labconco Protector Pass-Through Laboratory Fume Hoods 1136 Series - Manuel (Page 36)

Chapter 7: Modifying Your Protector Pass-Through
Product Service 1-800-522-7658 32
Original instructions
Installing Ceiling Enclosures Above the
Fume Hood
Your Protector Fume Hood has mounting holes to accept a ceiling enclosure to
close off the area between the top of the hood and the ceiling. Contact Labconco
Customer Service for ordering information. Ceiling Enclosures for Pass-Through
Hoods are handled as a specials request.
Figure 7-2
Installing Additional Service Fixtures
Additional service fixtures can be installed in the available service fixture holes in
both sidewalls and corner posts. The fume hood is factory set to accept up to four
valves per side. Contact Labconco Customer Service for information.
9827900 Cold Water Gooseneck, any position
9571000 Service Fixture CW, lower right, Pos. 1
9571001 Service Fixture CW, mid-lower right, Pos. 2
9571002 Service Fixture CW, mid-upper right, Pos. 3
9571003 Service Fixture CW, upper right, Pos. 4
9571004 Service Fixture CW, lower left, Pos. 1
9571005 Service Fixture CW, mid-lower left, Pos. 2
9571006 Service Fixture CW, mid-upper left, Pos. 3
9571007 Service Fixture CW, upper left, Pos. 4
9571100 Service Fixture GAS, lower right, Pos. 1
Figure 7-5 – Hose Connector Figure 7-3 - Knob Figure 7-4 - Valve