Labconco Protector Pass-Through Laboratory Fume Hoods 1136 Series - Manuel (Page 15)

Chapter 3: Getting Started
Product Service 1-800-522-7658 11
Original instructions
2. Find the hardware (bolts, washers, nuts) that attach the fume hood to
the skid and remove the hardware. The hardware is located on the
sides of the fume hood now exposed with the side panels removed.
Sash Weight Release
To protect the fume hood from damage in shipment, the sash weights have been
disconnected from the sash cables and secured to the side frame with a bolt. As
shown in Fig. 3-1 remove the two bolts and ensure sash cables are on pulleys
before attaching the weights. To access sash weights, remove Weight Cover.
NOTE: THE SASH WEIGHTS ARE INDIVIDUALLY
MATCHED FOR THIS SPECIFIC HOOD AND SHOULD NOT
BE EXCHANGED ON ANY OTHER UNIT.

Figure 3-1
Shipping Bolt
& Nut
(Discard)
Weight Cover
Cover Screws
(3 per cover)
Sash Weight