Labconco Protector XL Laboratory Hoods 1118 Series - Manuel (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Original instructions
munie d’un élévateur hydraulique et être placée en position sur
la surface de travail. Ne pas soulever par l’écoulement d'air du
devant.
Unpacking Your Fume Hood
Carefully remove the shrink-wrap or carton on your fume hood and inspect it for
damage that may have occurred in transit. If your unit is damaged, notify the
delivery carrier immediately and retain the entire shipment intact for inspection
by the carrier.
DO NOT RETURN GOODS WITHOUT THE PRIOR
AUTHORIZATION OF LABCONCO. UNAUTHORIZED
RETURNS WILL NOT BE ACCEPTED.
IF YOUR HOOD WAS DAMAGED IN TRANSIT, YOU MUST
FILE A CLAIM DIRECTLY WITH THE FREIGHT CARRIER.
LABCONCO CORPORATION AND ITS DEALERS ARE NOT
RESPONSIBLE FOR SHIPPING DAMAGES.
Do not discard the shipping skid or packing material for your fume hood until you
have checked all of the components and installed and tested the unit. The XL
fume hood baffles are shipped loose behind the hood and do not discard. The
upper baffle is 16.5" tall, the middle baffle is 23.3" tall, and the lower
perforated baffle is 17.3" tall. See Figure 1-1, Figure 3-1 and Figure B-1 that
shows proper XL baffle installation. Do not remove the fume hood from its
shipping skid until it is ready to be placed into its final location. Move the unit by
placing a flat, low dolly under the shipping skid, or by using a floor jack.
Do not move the hood by tilting it onto a hand truck.
Ne pas déplacer la hotte en le penchant sur un diable.
Removing the Shipping Skid
LEAVE THE FUME HOOD ATTACHED TO ITS SHIPPING
SKID UNTIL IT IS AS CLOSE TO ITS FINAL LOCATION AS
POSSIBLE. MOVE THE HOOD BY USING A SUITABLE
FLOOR JACK, OR BY PLACING A FURNITURE DOLLY
UNDERNEATH THE SKID. DO NOT MOVE THE HOOD BY
TILTING IT ONTO A HAND TRUCK.
After you verify the fume hood components, move your hood to the location
where you want to install it. Should you require disassembly to move the hood,
then follow the instructions in Appendix F. Then, follow the steps listed next to
remove the shipping skid from your unit.
The United
States
Interstate
Commerce
Commission
rules require
that claims
be filed with
the delivery
carrier
within fifteen
(15) days of
delivery.
!
)
)
)