Installation instructions, Adapting microwave blower for recirculation, Mount the microwave oven – Danby DOM161KBLSDD Manuel d'utilisation

Page 52

Advertising
background image

INSTALLATION INSTRUCTIONS

C4

ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION

(cont.)

7

Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched, and
that they are properly secured.

8

Secure blower unit to microwave with the screw
removed in Step 4. Make sure the screw is tight.

9

Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.

Back of

Microwave

C5

MOUNT THE MICROWAVE OVEN

FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT:
Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
NOTE: We recommend using filler blocks if the cabinet
front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.

NOTE: When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.

1

Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four
lower tabs of
mounting plate.

2

Rotate front of oven
up against cabinet
bottom.

3

Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Microwave Oven Top

Equivalent to Depth

of Cabinet Recess

Self-Aligning Screw

4

Attach the microwave oven to the top cabinet.

21

Advertising