Danby DOM161KBLSDD - Manuel (Page 38)

INSTALLATION INSTRUCTIONS
TOOLS YOU WILL NEED
# 1 Phillips screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square
(optional)
Tin snips (for cutting
damper, if required)
Electric drill with 3 ⁄
16
″, 1 ⁄
2
″ and 5 ⁄
8
″
drill bits
Hammer (optional) Stud finder
or
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed bottom
cabinet installations only)
Gloves
Saw (saber, hole or keyhole)
Level
Duct and masking tape
Scissors
(to cut template, if necessary)
Safety goggles
MOUNTING SPACE
Backsplash
66 ″ or More
from the Floor
to the Top of
the Microwave
30
″
2 ″
30 ″
min.
16 1 ⁄
2
″
Bottom Edge of
Cabinet Needs to
be 30 ″ or More
from the Cooking
Surface
NOTES:
• The space between the cabinets must be 30’’ wide and
free of obstructions.
• If the space between the cabinets is greater than 30’’,
a Filler Panel Kit may be used to fill in the gap
between the microwave oven and the cabinets. Your
Owner’s Manual contains the kit number for your
model.
• This microwave oven is for installation over ranges up
to 36’’ wide.
• If you are going to vent your microwave oven to the
outside, see Hood Exhaust Section for exhaust duct
preparation.
• When installing the microwave oven beneath
smooth, flat cabinets, be careful to follow the
instructions on the top cabinet template for
power cord clearance.
7