Danby DOM161KBLSDD - Manuel (Page 48)

INSTALLATION INSTRUCTIONS
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
3
Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
Back of
Microwave
Back of
Microwave
4
Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting After Rerouting
Wires Routed Through Right Side Wires Routed Through Left Side
5
Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
Before Rolling After Rolling
Back of
Microwave
Back of
Microwave
6
Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End A
End B
NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
Do not pull or stretch the blower unit wiring. Make sure the
wires are not pinched, and that they are properly secured.
CAUTION
7
Secure the blower unit to the microwave with
the original screw.
Blower Plate
Blower Motor
Screw
Back of
Microwave
8
Replace the blower plate in the same position
as before with the screw. Make sure the screw
is tight.
9
Attach the exhaust adaptor to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Guide
Guide
Adaptor
Locking Tabs
Back of
Microwave
Push in securely until it is in the lower locking tabs. Take
care to assure that the damper hinge is installed so that it
is at the top and that the damper swings freely.
17