Danby DOM161KBLSDD - Manuel (Page 46)

INSTALLATION INSTRUCTIONS
OUTSIDE BACK EXHAUST
(Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Exhaust Adaptor
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
• Make sure the screws for the
blower motor and blower plate
are securely tightened when they
are reinstalled. This will help to
prevent excessive vibration.
• Make sure the motor wiring has
been properly routed and
secured, and that the wires are
not pinched.
B1
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
• Read the instructions on the REAR WALL TEMPLATE.
• Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall plate.
• Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
REMOVE EXHAUST ADAPTOR
B2
This microwave oven is shipped assembled for top
exhaust. You will need the exhaust adaptor for
installation in the rear wall opening. To remove the
exhaust adaptor from the microwave oven:
1
2
Remove tape securing damper.
Raise damper flap.
Blower Plate Blower Plate
Back of
Micowave
Slip the damper
out of the track
on the blower
frame by pressing
and twisting
both ends.
3
4
Remove and save the screw that holds the blower
plate to the microwave. Lift off the blower plate.
Back of
Microwave
Blower Plate
B
15