Connections, 8 connections, Connecting the audio components – Denon AVR-1803 Manuel d'utilisation

Page 9: English, Digital audio

Advertising
background image

ENGLISH

9

R

L

R

L

R

INPUT

OUTPUT

L

R

L

R

OUTPUT

L

R

L

INPUT

OPTICAL

COAXIAL

OUTPUT

OPTICAL

L

R

L

R

L

R

L

R

OUTPUT

DIGITAL AUDIO

DIGITAL AUDIO

DIGITAL AUDIO

DIGITAL AUDIO

B

B

8 CONNECTIONS

• Do not plug in the AC cord until all connections have been

completed.

• Be sure to connect the left and right channels properly (left with

left, right with right).

• Insert the plugs securely. Incomplete connections will result in the

generation of noise.

Use the AC OUTLETS for audio equipment only. Do not use

them for hair driers, etc.

• Note that binding pin plug cords together with AC cords or placing

them near a power transformer will result in generating hum or
other noise.

• Noise or humming may be generated if a connected audio

equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.

Connecting the audio components

• When making connections, also refer to the operating instructions of the other components.

The power to these outlets is turned on and off when the power is switched between on and standby from the remote control unit or power
switch.

CD player

Connecting a CD player

Connect the CD player’s analog output jacks
(ANALOG OUTPUT) to this unit’s CD jacks using
pin plug cords.

Connecting a turntable

Connect the turntable’s output cord to the AVR-1803/883’s PHONO
jacks, the L (left) plug to the L jack, the R (right) plug to the right jack.

NOTES:
• This unit cannot be used with MC cartridges directly. Use a

separate head amplifier or step-up transformer.

• If humming or other noise is generated when the ground wire is

connected, disconnect the ground wire.

Turntable

(MM cartridge)

Ground
wire

Connect the internal amplifier’s subwoofer to the
subwoofer terminal. (Refer to page 17.)

AC OUTLETS
• SWITCHED

(total capacity – 120 W (1 A.))

The power to these outlets is turned on and off in conjunction with the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit.
No power is supplied from these outlets when this unit’s power is at standby.
Never connect equipment whose total capacity is above 120 W (1 A.).

NOTE:

Only use the AC OUTLETS for audio equipment. Never use them for hair
driers, TVs or other electrical appliances.

Connecting the AC OUTLETS

AC CORD

AC 120 V, 60 Hz

Connecting a tape deck

Connections for recording:
Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s tape
recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s tape
playback (CDR/TAPE IN) jacks using pin plug cords.

CD recorder or Tape deck

Route the connection cords, etc., in such a way
that they do not obstruct the ventilation holes.

MD recorder, CD recorder or other component
equipped with digital input/output jack

CD player or other
component equipped
with digital output jacks

Connecting the DIGITAL jacks

Use these for connections to audio (video) equipment with digital output. Refer to page 24
for instructions on setting this terminal.

NOTES:
• Use 75

/ohms cable pin cords for coaxial connections.

• Use optical cables for optical connections, removing the cap before connecting.

NOTE:
If humming noise is generated by a
tape deck, etc., move the tape deck
away.

Subwoofer jack

Advertising