Denon AVR-1803 - Manuel (Page 15)

ENGLISH
15
Connecting the ZONE2 jacks
• If another pre-main (integrated) amplifier is connected, the ZONE2 jacks can be used to play a different program source in ZONE2 at the same
time.
L
R
+ +
OUTPUT INPUT
AUX OUT B
ZONE2
RC-616
INFRARED RETRANSMITTER
Integrated pre-main amplifier
RC-617
INFRARED SENSOR
Connecting the SURROUND BACK / ZONE2 speaker system
To use the surround back speaker in the MAIN ZONE:
• Set the POWER AMP ASSIGN switch to “SURR. BACK”. Then plug in the AC main again.
• The same signal is output simultaneously to the SURR. BACK A and B terminals.
To use the ZONE2 speaker system in ZONE2:
• Set the POWER AMP ASSIGN switch to “ZONE 2”. Then plug in the AC main again.
• The same signal is output simultaneously to the ZONE 2 A and B terminals.
NOTE:
• To use surround back with one speaker, to SURR. BACK A CH.
Surround back speaker can be used A + B.
NOTE:
• To use ZONE2 with one speaker, to ZONE2 A CH.
ZONE2 speaker can be used A + B.
(A) (B)
MAIN ZONE
(A) (B)
ZONE2
(Rear panel)
(Rear panel)