Denon AVR-1803 - Manuel (Page 34)

ENGLISH
34
3 Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
(Main unit) (Remote control unit)
4 Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5 Adjust the volume.
To select the surround mode while
adjusting the surround parameters,
channel volume or tone control,
press the surround mode button
then operate the selector.
(Main unit)
(Main unit) (Remote control unit)
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0
to 18 dB, in steps of 1 dB. However, when the channel
level is set as described on page 41, if the volume for any
channel is set at +1 dB or greater, the volume cannot be
adjusted up to 18 dB. (In this case the maximum volume
is adjusted to “18 dB — (Maximum value of channel
level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
Input mode display
ANALOG DIGITAL
DIGITAL
DIGITAL
ANALOG
AUTO PCM DTS
INPUT
AUTO PCM DTS
INPUT
AUTO PCM DTS
INPUT
AUTO PCM DTS
INPUT
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
One of these lights, depending on the
input signal.
Input signal display
SIGNAL
DIGITAL
DIGITAL
DIGITAL
SIGNAL
SIGNAL
• DOLBY DIGITAL
• DTS
• PCM
The indicator lights when digital signals are being input
properly. If the indicator does not light, check whether
the digital input component setup (page 24) and connections are
correct and whether the component’s power is turned on.
DIGITAL
DIGITAL
NOTE:
• The
indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIGITAL