Sony MDS-JA50ES - Manuel (Page 9)

Basic Operations
Press # REC.
The deck becomes ready to record.
Adjust the recording level.
When recording through the DIGITAL IN COAXIAL, 0PT1, or 0PT2
connector
Setting the DIGITAL REC LEVEL control at 0 is satisfactory for
most purposes. For details, see page 13.
When recording through the LINE(ANALOG) IN connectors
Setting the ANALOG REC LEVEL L/R controls at 4 is
satisfactory for most purposes. For details, see page 14.
Press ► or I I .
Recording starts.
8 Start playing the program source.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press = OPEN/CLOSE to take out the MD or
change the deck to standby by pressing POWER. "TOC Writing" will flash in
the display at this time.
After "TOC Writing" stops flashing and goes out, you can pull out the AC
power cord.
To Press
Stop recording ■
Pause recording* II. Press the button again or press ► to resume
recording.
Take out the MD ^ OPEN/CLOSE after stopping
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.