Tweco 100XL Plus CE PAK Master - Manuel (Page 21)

Manual 0-2813 3-5 INSTALLATION
Adapter
Connector
Pilot Lead Stud
Strain Relief
Nut
Strain Relief
Shielded Torch Leads
with O2B Connector
Pilot Lead
Negative/Plasma
Lead
Torch Control
Connectors
Shield
Connectors
A-03678
Power Supply Bulkhead
May Differ from Type Shown
Figure 3-5 Connecting SL100 Torch with O2B
Connector
6. Connect the torch Negative/Plasma Lead to the bulk-
head connection inside the Power Supply.
7. Connect the PIP and Shield Cables to the mating
connectors on the Adapter supplied on the Power
Supply.
8. Remove the top nut and washer from the Pilot
Stud.
9. Place the lug on the Pilot Control Wire onto the
stud and secure with the nut and washer removed
in the above Step.
10. Tighten the Strain Relief onto the Torch Leads.
11. Check the torch for proper parts assembly.
12. Close the access panel and turn the latching screw.
B. ConnectingSL100 torch with ATC
Connectors
Torches with shielded leads and ATC connectors connect to a
shielded ATC Adapter which connects to the power supply
bulkhead.
WARNING
Disconnect primary power at the source before
disassembling the torch or torch leads.
Strain Relief
Nut
Strain Relief
Shielded ATC Adapter
Pilot Lead
Negative/Plasma
Lead
Torch Control
Connectors
Shield
Connector
Shield
Connector
A-03677
Through - Hole protector Nut Removal
1. Remove the Through - Hole protector Nut from the
Through - Hole protector. Inside the Power Supply
Bulkhead area, route the connectors on the free end of
the Adapter through the Through - Hole protector Nut.
2. Fit the ATC Adapter end and the Through - Hole pro-
tector into the hole in the unit.
3. Secure the Through - Hole protector with the retaining
nut removed earlier.
4. Connect the ATC Adapter Negative / Plasma Lead to
the bulkhead connection inside the Power Supply.
5. Remove the top nut and washer from the Pilot Stud.
6. Connect the pilot lead terminal to the stud and secure
with the nut and washer removed previously.