Quadra-Fire QFP44 - Manuel (Page 43)

Quadra-Fire • QFP44 • 4051-300 Rev M • 09/08 43
G. Install RF4-8
The RF4-8 may be used in place of the roof À ashing and
storm collar.
Pipe must be supported within 12 in. (305 mm) of the
rooÀ ine using plumbers strapping when using the RF4-8
Flashing. Refer to Sect. 10.C. Securing Vent Sections.
• Trim the rubber boot (using scissors or a utility knife),
cutting along the marked measurement lines. See Figure
10.15. Use the 210 mm line for DVP pipe.
• Lubricate pipe or À ue with water and slide the À ashing
down. It may be necessary to trim the top shingles
around the base of the rubber boot to ensure a good
¿ t.
• Draw around À ashing, remove À ashing.
• Apply silicone sealant to roof inside the lines (Figure 10.15)
•
Lubricate pipe or À ue with water and slide À ashing down.
Seat ¿ rmly in sealant. Nail roof À ashing to the roof.
• Apply silicone sealant on the top and side edges of the
À ashing. See Figure 10.17. Install shingles, Apply sealant
at the top edge of the rubber boot. See Figure 10.18.
• We recommend that you top coat with conventional
acrylic house paint to improve the appearance of your
galvanized base À ashing.
Figure 10.15 Trim Rubber Boot
Figure 10.17 Slide Flashing Down, Secure & Apply Sealant
Figure 10.18 Installation Complete
Figure 10.16 Apply Sealant
The SLP-FS
shown in this
photo will not
be used with
DVP pipe.
SLP-FS
Apply Sealant
Top & Partial Sides
Shingles Trimmed
Shingles over
Flashing
Flashing over
Shingles
Silicone Sealant
(top of boot)