Quadra-Fire QFP44 - Manuel (Page 37)

Quadra-Fire • QFP44 • 4051-300 Rev M • 09/08 37
A. Secure and Level the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of
blown-in insulation. Make sure insulation and other
materials are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause
overheating and ¿ re.
The diagram shows how to properly position and secure
the appliance (see Figure 9.1). Nailing tabs are provided to
secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs À ush with the framing.
• Level the appliance from side to side and front to
back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the À oor by inserting two screws
through the pilot holes at the bottom of the appliance.
Figure 9.1 Proper Positioning and Securing of an Appliance
9 9
Appliance Preparation
NOTICE: The bottom of the door frame at time of
installation will be À ush with the bottom of the unit. Keep
À oor or hearth covering À ush with the bottom of the unit
or the door will not ¿ t on the unit.