Quadra-Fire QFP44 - Manuel (Page 19)

Quadra-Fire • QFP44 • 4051-300 Rev M • 09/08 19
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, glass cleaner, drop
cloth and a stable work surface.
CAUTION! Handle ¿ xed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
•
Prepare a work area large enough to accommodate ¿ xed
glass assembly and door frame by placing a drop cloth
on a À at, stable surface.
Note: Fixed glass assembly and gasketing may have
residue that can stain carpeting or À oor surfaces.
• Remove door or decorative front from ¿ replace and set
aside on work surface.
• See Section 14.A for instructions to remove ¿ xed glass
assembly.
• Clean glass with a non-abrasive commercially available
cleaner.
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial ¿ replace glass cleaner
(consult with your dealer)
• Carefully set ¿ xed glass assembly in place on ¿ replace.
Hold glass in place with one hand and secure glass
latches with the other hand.
• Reinstall door or decorative front.
3 3
Maintenance and Service
A. Maintenance Tasks-Homeowner
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any of
the listed tasks, please call your dealer for a service ap-
pointment.
More frequent cleaning may be required due to lint from
carpeting or other factors. Control compartment, burner
and circulating air passageway of the ¿ replace must be
kept clean.
CAUTION! Risk of Burns! The ¿ replace should be
turned off and cooled before servicing.
When properly maintained, your ¿ replace will give you
many years of trouble-free service. We recommend an-
nual service by a quali¿ ed service technician.
Doors, Surrounds, Fronts
Frequency: Annually
By: Homeowner
Tools needed: Protective gloves, stable work surface
• Assess condition of screen and replace as necessary.
•
Inspect for scratches, dents or other damage and repair
as necessary.
• Check that louvers are not blocked.
• Vacuum and dust surfaces.
Any safety screen or guard removed for servicing must be
replaced prior to operating the ¿ replace.
Installation and repair should be done by a quali¿ ed
service technician only. The ¿ replace should be inspect-
ed before use and at least annually by a professional
service person.
Remote Control
Frequency: Seasonally
By: Homeowner
Tools needed: Replacement batteries and remote control
instructions.
• Locate remote control transmitter and receiver.
• Verify operation of remote. Refer to remote control
operation instructions for proper calibration and setup
procedure.
• Place batteries as needed in remote transmitters and
battery-powered receivers.
• Place remote control out of reach of children.
If not using your ¿ replace for an extended period of time
(summer months, vacations/trips, etc), to prevent unin-
tended operation:
• Remove batteries from remote controls.
• Unplug 3 volt adapter plug on IPI models.