Panasonic WV-CU161 - Manuel (Page 23)

23
(4) Parity Check Setting
This item lets you set the parity bit for RS-485 communica-
tion.
1. Display the COMMUNICATION menu.
2. Select PARITY CHECK by moving the joystick up or
down.
3. Select NONE, EVEN or ODD for parity check by moving
the joystick to the right or left.
The initial factory setting is NONE.
Note: This setting must be compatible with the peripherals
connected.
(5) Stop Bit Setting
This item lets you set the number of stop bits for RS-485
communication.
1. Display the COMMUNICATION menu.
2. Select STOP BIT by moving the joystick up or down.
3. Select 1 or 2 for the number of stop bits by moving the
joystick to the right or left.
The initial factory setting is 1 bit.
Note: This setting must be compatible with the peripherals
connected.
(6) Wait Time Setting
This item lets you set the waiting time in milli-seconds (ms)
till retry for RS-485 communication.
1. Display the COMMUNICATION menu.
2. Select WAIT TIME by moving the joystick up or down.
3. Select OFF, 100, 200, 400, or 1 000 ms for the wait time
by moving the joystick to the right or left.
The initial factory setting is OFF (No retry).
(7) Delay Time Setting
This item lets you set the lowest delay time from the recep-
tion of data to reply for RS-485 communication.
1. Display the COMMUNICATION menu.
2. Select DELAY TIME by moving the joystick up or down.
3. Select OFF, 20, 40, or 100 ms for the delay time by
moving the joystick to the right or left.
The initial factory setting is OFF.
(8) XON/XOFF Setting
This item lets you set flow control for RS-485 communica-
tion.
1. Display the COMMUNICATION menu.
2. Select XON/OFF by moving the joystick up or down.
3. Select NOT USE or USE mode for XON/XOFF by mov-
ing the joystick to the right or left.
The initial factory setting is NOT USE.