Communication setting – Panasonic WV-CU161 Manuel d'utilisation

Page 22

Advertising
background image

22

9. To return to the preset data menu, press the

HOME/ESC button after completing the data title set-
ting.

To replace a specific character

1. Use the joystick to shift the cursor to the selected char-

acter area.

2. Move the cursor to the character to be replaced by

moving the joystick right or left.

3. Move to shift the cursor to the character area by moving

the joystick up or down, and move the cursor to the
desired character by moving the joystick up, down,
right or left.

4. Press PRESET/SET/PROGRAM PRESET button.

The selected character is replaced with the corrected
character area.

To delete a specific character

A character is deleted by inserting a blank space.

1. Use the joystick to shift the cursor to the selected char-

acter area.

2. Move the cursor to the character to be deleted by mov-

ing the joystick right or left.

3. Move the cursor to the SPACE position by moving the

joystick up or down.

4. Press the PRESET/SET/PROGRAM PRESET button.

[•] (space mark) appears in place of the deleted char-
acter.

COMMUNICATION

UNIT ADDRESS 1
BAUD RATE 19200
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
WAIT TIME OFF
DELAY TIME OFF
XON/XOFF NOT USE

(1) Unit Address Setting

This item lets you set a unit address that is set to the cam-
era for RS-485 communication. After confirming the unit
address that is set to the camera, set it up.

1. Display the COMMUNICATION menu.
2. Select UNIT ADDRESS by moving the joystick up or

down.

3. Select the unit address assigned to the combination

camera in the range of 1 to 96 by moving the joystick to
the right or left.
The initial factory setting is 1.

Note:

If the unit address is not the same, the camera can-

not be operated.

(2) Baud Rate Setting

This item lets you set the baud rate for RS-485 communica-
tion.

1. Display the COMMUNICATION menu.
2. Select BAUD RATE by moving the joystick up or down.
3. Select 19200, 9600, 4800 or 2400 bps for the baud rate

by moving the joystick to the right or left.
The initial factory setting is 19200 bps.

Notes:

• At a baud rate of 2400 bps, the data response may be

unstable when an alarm is reset, for example.

• This setting must be compatible with the peripherals

connected.

(3) Data Bit Setting

This item lets you set the number of the data bits for RS-485
communication.

1. Display the COMMUNICATION menu.
2. Select DATA BIT by moving the joystick up or down.
3. Select 7 or 8 bit for the number of data bits by moving

the joystick to the right or left.
The initial factory setting is 8 bit.

Note:

This setting must be compatible with the peripherals

connected.

Communication Setting

Note:

The COMMUNICATION menu appears when the

Data Switch is set to RS-485.

Advertising