Pioneer KURO PRO-151FD - Manuel (Page 29)

29
En
02 Install Your Flat Panel TV
2.6 Connect to Broadcast TV & Other Devices (DVR, Receiver, BDR, etc.)
The type of equipment attached to your flat panel TV determines which panel ports are used. The following
sections explain how to connect broadcast TV and playback equipment such as a DVD player, Surround Sound
system, video recorder, etc. to the panel. If your equipment is not listed, please refer to the operating instructions
that came with the device(s) for connection assistance.
2.6.1 Add Analog (conventional) and Digital TV Channels
Whether a TV station broadcasts in Analog or Digital, your flat panel TV shows the programs as long as the panel
is programmed to accept the signal. To program your panel for broadcast TV, select terminal ANT.
The ANT terminal accepts both analog and digital
broadcasts. Connect a VHF/UHF antenna and/or cable TV
to the panel’s rear ANT terminal, then press
TV/DTV on
the remote control to toggle between analog and digital
broadcasts. When watching analog TV channels, you can
also use an outdoor antenna for the clearest analog
picture.
If your outdoor antenna uses a 75-ohm coaxial cable with
an F-type connector, plug it into the panel’s antenna
terminal on the back.
2.6.2 Connect Your Other Pioneer Equipment
This section provides cabling information for your other
Pioneer equipment when combined with the panel. Each diagram can also be used as a reference tool for non-Pioneer
devices but port locations may differ or be unavailable.
Connect cable or Satellite using STB (Set Top Box):
T
W
T
W
In order to watch both analog and
digital broadcasts through your
terrestrial antenna or cable
connection, you must first connect
the antenna cable to a splitter.
Rear view
When using a cable STB or Satellite STB, plug in to the antenna/cable TV wall outlet using the STB cable provided
with your STB. If your STB has an HDMI terminal, use any of INPUT 4 through INPUT 6 (HDMI terminal) on the rear
or INPUT 7 (HDMI terminal) on the side of the flat panel TV instead of making video connections. If you connect an
antenna cable directly to TV, you must first connect the cable to a splitter. For details, refer to the operating manual
that came with the STB.
IN HDMI OUT
OUT
AUDIO OUT
COMPONENT VIDEO OUTPUT
Y
P B
P R
T
W
T
W
IN HDMI OUT
OUT
AUDIO OUT
COMPONENT
VIDEO OUTPUT
Y
P B
P R
SAT IN
Rear view
Satellite antenna
Cable STB/Satellite STB Cable STB/Satellite STB
PRO151FD.book Page 29 Wednesday, April 2, 2008 10:19 AM